https://www.ozervnews.com

T1 That's the best one that has been on offer, so far.
I like it

I'm not sure if I have NZ to scale or in the right latitude to the big island, I took off here as it said it was royalty free and ok to crop, then butched it in Powerpoint and Microsoft paint

T1 Terry wrote:I'm not sure if I have NZ to scale or in the right latitude to the big island, I took off here as it said it was royalty free and ok to crop, then butched it in Powerpoint and Microsoft paint

I vote for it, the distance thing don't matter, closer ties n all that

Then should it be ONZeRVnews ?

T1,

Don't worry about distance relativities etc...
After all, pre-federation we almost had NZ as another state in "Australasia"!

I like your layout. Perhaps a bit more long grass at the base of the posts?
Isn't that the Aussie Way? 'The Victa can't reach it, therefore it's not worth cutting...'


However, that means i'll have to break out the razor blade to remove my 'steering wheel' FORUM sticker.
Good thing I only put up one...

Where are you planning to put Tassie

Every red blooded male knows where the map of tassie is Dottie

If you do a Google search you will find NZ was part of the state of NSW at one stage, govt wise, not attached

BruceS wrote:Before we go getting a quote etc perhaps we need to decide if we need NZ on it too?

Put NZ on it and I will proudly display it on both ends of our van

Cheers Chris

JUST-A-THORT...

T1,
To conform to the bumper-sticker format (about 9"x2.5"), you'd have room to put the elements side-by-side.
ie: Oz on left, banner in centre (with or without roo), NZ on right.

Could you put up a version in this vein for us to assess

One day I'm going to put a rear bumper on Ray!!!
For visability at a bit of distance it may be better 9" X 9" square rather than a longer skinny one?
(or 8" X 8" etc?)
Maybe both? Bumper one for front & square on rear? Let the people decide where to put each one?