Page 110 of 123
Re: Bernie and Carols Isuzu fit out.
Posted: Sun Jul 30, 2017 12:41 pm
by BruceS
Don't think you'll be going anywhere this week Bernie!!
I wonder if it might pay to have a separate air cleaner for the compressor air inlet to reduce the suction PSI? (vacuum)
Something like on a normal workshop air compressor. As long as it can be installed up a bit higher out of the road dust swirling around.
On the other hand if the rings don't get some oil ...................
Are they just splash fed or engine oil pressure to the main bearing. ??
Re: Bernie and Carols Isuzu fit out.
Posted: Sun Jul 30, 2017 12:57 pm
by BernieQ2
Pressure Bruce , that hole on the bottom of the Compressor is the oil pressure inlet you asked me about it a while ago I didn't think it was at the time.
Bernie
Re: Bernie and Carols Isuzu fit out.
Posted: Sun Jul 30, 2017 3:36 pm
by SteveW
Does this help?
DSCF2780 (Custom).JPG
Re: Bernie and Carols Isuzu fit out.
Posted: Sun Jul 30, 2017 4:08 pm
by BernieQ2
Thanks Steve...better.
Bernie
Re: Bernie and Carols Isuzu fit out.
Posted: Sun Jul 30, 2017 4:52 pm
by BruceS
Obviously lots of experience in the CIB branch Steve?
It's called fabrication!!!
Better see if you can fix up my Facebook image? !!
Sometimes I just gotta laugh at some shops security cameras! Not sure exactly how a perp can be identified.
Re: Bernie and Carols Isuzu fit out.
Posted: Tue Aug 01, 2017 1:33 pm
by BernieQ2
!!!!!!!!!! SHAZAM !!!!!!!!!!!
What a lot of FFFFFFFFFFnfun that was. They was a sneaky little oil line I missed this day but its out .Took a bit to spot it .
Yesterday removed the pump gear with the help of a twin puller only two hole in the gear wheel , when it let go it frightened the bejesus out of me hit my glass's then landed on my knee...I survived .
Todays pic's .
Bernie .
Nearly forgot there is about a 1/8th" movement on the compressor pump shaft up and down . Good thing I didn't just do a top end fix..
DSCF2783 (Custom).JPG
DSCF2785 (Custom).JPG
DSCF2784 (Custom).JPG
Re: Bernie and Carols Isuzu fit out.
Posted: Tue Aug 01, 2017 1:58 pm
by Newcastle George
Bernie, I think I can see the screw for adjusting the fuel in pic 1, beneath the yellow dot.
George
Re: Bernie and Carols Isuzu fit out.
Posted: Tue Aug 01, 2017 3:39 pm
by BernieQ2
You could be on the money George , I have removed the plastic cover and its a adjustable bolt/screw .
Bernie .
DSCF2786 (Custom).JPG
Re: Bernie and Carols Isuzu fit out.
Posted: Thu Aug 03, 2017 7:23 am
by BernieQ2
Cant seem to send this on the other web site Bruce so its here .
And in my hand as requested .
Bernie .
DSCF2788 (Custom).JPG
Re: Bernie and Carols Isuzu fit out.
Posted: Thu Aug 03, 2017 8:39 am
by BruceS
Looks good Bernie. You'll have to try to install it in an easy to get to place so you can watch the level & empty it without mess when needed. Might need hose that is oil resistant and won't suck flat when it gets warm.
How did you get those finger nails so clean? Gloves when on the job?