Just need Julie on traffic control George ? .
Bernie .
What did you do to your rig today?
-
jon_d
- Posts: 4679
- Joined: Thu Apr 11, 2013 6:37 pm
- Location: bedford
- Has thanked: 42 times
- Been thanked: 36 times
Re: What did you do to your rig today?
c'mon George, give it rev, what about up and down the drive away?
There are worse and better places to get wet...You're still going to get wet between the bus door and the annexe.
-
BruceS
- Site Admin
- Posts: 9305
- Joined: Thu Nov 22, 2012 7:32 pm
- Location: Mannum, SA, 5238
- Has thanked: 36 times
- Been thanked: 36 times
Re: What did you do to your rig today?
Another load into storage.
Passed Terry in THIS and he never even noticed me waving!
Must have looked funny with my boat up top passing Terry in Brians red bullet with HIS boat up top.
You got a double over drive in that Brian? By joves it flies!!
Passed Terry in THIS and he never even noticed me waving!
Must have looked funny with my boat up top passing Terry in Brians red bullet with HIS boat up top.
You got a double over drive in that Brian? By joves it flies!!
You do not have the required permissions to view the files attached to this post.
*******************
BruceS
Mannum, SA
********************
BruceS
Mannum, SA
********************
-
Dot
- Posts: 24722
- Joined: Fri Nov 23, 2012 6:12 pm
- Location: Strathalbyn SA
- Been thanked: 37 times
Re: What did you do to your rig today?
Ooooh you naughty boy Jon 
but I like you..
but I like you..Queen of the Banal & OT chatter and proud of it. If it offends you then tough titty titty bang bang.
Re: What did you do to your rig today?
No rest for the wicked...well me anyway herself does nuffin...good thing she cant see this I recon .
WE finished the annex as far as we can at the present .
End wall made finished and erected . Was harder then the long side due to the angles but all good and finished just in time its now raining .sorry pouring .
Here's todays effort .
WE finished the annex as far as we can at the present .
End wall made finished and erected . Was harder then the long side due to the angles but all good and finished just in time its now raining .sorry pouring .
Here's todays effort .
You do not have the required permissions to view the files attached to this post.
Re: What did you do to your rig today?
Ouch that hurt ...buggar she read my post .
So I better put the better half up hard at it .
Also regarding the diesel heater it all working good now .
So I better put the better half up hard at it .
Also regarding the diesel heater it all working good now .
You do not have the required permissions to view the files attached to this post.
-
Newcastle George
- Posts: 3284
- Joined: Wed Dec 05, 2012 3:21 pm
- Location: Kotara, Newcastle
- Has thanked: 2 times
- Been thanked: 8 times
Re: What did you do to your rig today?
GeorgeBernieQ wrote:Ouch that hurt ...buggar she read my post .
So I better put the better half up hard at it .
Also regarding the diesel heater it all working good now . So, what were you doing wrong
George, Julie, Leonie & Sean - Kotara, Newcastle
DIY 11.5M 1979 Bedford, Nissan/UD FE6T motor
DIY 11.5M 1979 Bedford, Nissan/UD FE6T motor
Re: What did you do to your rig today?
Not much all I done was change the pick up from before the electric pump to after the pump , just made it easy to prime removed pipe from pump turned ignition on and hey presto primed in a second or two replaced pipe all good .
Started up first time this morning .
Also I'm going to renew all the fuel lines to and from the engine a lot of hardness and cracking on the line .
$10 per metre here in town will be in Hervey Bay Friday celebrating so will check prices there .
Bernie .
Started up first time this morning .
Also I'm going to renew all the fuel lines to and from the engine a lot of hardness and cracking on the line .
$10 per metre here in town will be in Hervey Bay Friday celebrating so will check prices there .
Bernie .