https://www.ozervnews.com

Have a broken soap dish (tile) in the shower, as usual the discussion of how to do this replacement job is an issue I know some of you would have done this so let the info advice flow please..

I have to ask how did it get broken & where was G at the time?

If the tiles were stuck on properly you should have enough room around the edge of the tile to rake out the mortar.
A broken hacksaw blade is a handy tool to do it.
Don't rush it........... Take your time.
Once a gap right around it you should be able to prize out the broken one. If not maybe a centre punch close to one corner will break off enough to get behind the tile.
Please put a big spread sheet down first. Makes for a grumpy G if it pops out & breaks a floor tile as well!!!

It got broken when I fell against it over 12mths ago and I was in there on my own to be sure to be sure.. I shall pass on your instructions with a smile and "I told you so"

My renovator would have done it ,no sweat. But I brought it home.

The BOSS could do it for you but not sure when we will be your way he did lots when he had his small business

Cheers Ros

They are not foot holds Dot! Wait until Norman returns with his Renovator and use his elbow grease.

Ros I shall keep it just as it is for him so he still feels loved. Jon, I could not lift my foot that high so it must be a soap dish, Norman and his renovator

Dot, Will you let the master renovator know that I reckon it's a pretty good effort.

He said thank you , it was a b****** of a job to get it cleaned up before he could start. Looked like the tiler had used the same stuff as what is used for the concrete floors.. Couldn't separate the adhesive from the backing board very easily at all..