Good morning daily

[Dot]

morning one and all. Cooler today,

[BernieQ2]

Good morning.
Had another day off
We had a thunder storm yesterday arvo will check what fell from the sky later...the tanks are overflowing.
Forecast for today is rain.
Bernie.

[bob r]

Morning Bernie and any others up
No rain here yesty little man recons today is the day
Had another trip to Harvey Bay yesty bloody drs once they get a hold of you they won't let go

Bob

[supersparky]

Good morning everyone. Your right about the docs, Bob. I had a teleconference with mine yesty, going to need an MRI on my neck and a CT scan on the lungs now, apparently. We drove up to Hervey Bay. Will be here til the weekend. Babysitting a dog. Looks like another good day to be in the pool.
Safe travels everybody, happy hump day.

[Newcastle George]

Good morning/afternoon, raining here and the same forecast for the next ten days but at least the temperature has dropped however, I can't say the same for the humidity.

George

[jon_d]

Morning all.

Just back from getting some chain; having to pull the engine out to replace the clutch in the bus. Worst job. grrrr.

[supersparky]

The amount of times that you have hauled out the engine and g/box you should be able to do it in your sleep.

[jon_d]

Yep, Almost a nightmare. Just steady work. At the point to slip the hoist in and start to undo the mounts. And then man handle 800kgs of cold steel.

[T1 Terry]

Yep, Almost a nightmare. Just steady work. At the point to slip the hoist in and start to undo the mounts. And then man handle 800kgs of cold steel.

Not easier to just unbolt the gearbox and hang that on a sling through the floor? Learnt that trick while working for a bus yard in Tassie. Had to change the clutch on the side of the road just out of Hobart, all went fine until I tried to lift the gearbox back in .... ended up with it sitting on my chest because I was too exhausted to lift it either up into place for one more try or roll it off me ..... just lucky another bus driver stopped for a chat and found me pinned under there and rescued me .... every bus clutch job after that involved a hatch cut in the floor ....

T1 Terry

[jon_d]

Unfortunately not. It's tucked up to high and cross members and floor joists are in the way.