Good morning daily

[Dot]

Dot, why can't you flush with the lid up. Sometimes its the most exciting part of the exercise.

You just might get splattered. but knowing T1 he might want to try and see if I am right or wrong. Do it with a full load.

[BernieQ2]

Good morning.
Too much information Dot
The fridge is in...not to be removed again...I hope
Microwave also in just the pretty stuff left to do...picture frame stuff
I should with a bit of luck turn the fridge on today to give it a run so to speak. Might put a can of beer in to celebrate
Bloody Terry...I almost forgot the diesel heater tank will have to get back to that soon.
Neighbor's little house is now due to arrive on Monday, the truck had to do a run up north.
Auspost talking to mate over the back...he bought a new fuel cap for his vintage motor bike...from Brisbane, tracking showed it was sent to Mareeba far north QLD then to Cairns ...he got InTouch with Auspost they said it was lost next he see's it back in Brisbane he may get it this year
I don't worry about spelling gramma mistakes...if you can read it it's fine.
That was it for yesterday.
Keep safe.
Bernie.

IMG20240412160124.jpg

[Newcastle George]

Good morning All.
Bernie, do you have to use a step ladder to get to the microwave?

On Thursday morning I ordered a Torque Multiplier from Regents Park, Sydney, for delivery via Aust Post. Shown below are the tracking details. I should point out that Chullora id SW of Regents Park and Mayfield is slightly north of here.

Item processed at facility

SYDNEY NSW • Thu 11 Apr, 10.42pm

Item processed at facility,at SYDNEY NSW,on Thu 11 Apr, 10.42pm
In transit to next facility in NEWCASTLE NSW

Fri 12 Apr, 2.15am

In transit to next facility in NEWCASTLE NSW,on Fri 12 Apr, 2.15am
Transferred

CHULLORA NSW • Fri 12 Apr, 3.17am

Transferred,at CHULLORA NSW,on Fri 12 Apr, 3.17am
Arrived at facility

MAYFIELD WEST NSW • Fri 12 Apr, 6.18am

Arrived at facility,at MAYFIELD WEST NSW,on Fri 12 Apr, 6.18am
Picked up from Sender

CHULLORA NSW • Fri 12 Apr, 4.45pm

Picked up from Sender,at CHULLORA NSW,on Fri 12 Apr, 4.45pm
In transit

CHULLORA NSW • Fri 12 Apr, 4.47pm

George

[T1 Terry]

Terry your loo sounds like someone has done things back to front, here is how you use it...
1/ lift the loo lid
2/ sit down and do your business
3/ Put the lid down
4/use the foot pedal by a short sharp push down.
5/ If there was streaks then lift the pedal up to put a bit more water in the bowl to clean it.
6/ PUT the lid down and flush again.
Never flush the loo with the seat up

We usually turn on the water pump on before using the loo..
When G installed ours he increased the height to the height of the house loo. .

Tried that method originally, no success, blocked every time. Tried just holding the pedal down but part way through the download, I got wet gonads, the bowl had filled with water. Learnt from there to turn the water pump off.
Next we tried it without the water running but full vacuum built up, still blocked. So the method we use listed above works every time, just a nuisance having to go through such a process.
Maybe it's the U turn the pipe does behind the toilet the wall. It goes up around a mtr, a short join and then back down, then across the floor and through the hole to the maze of bends that gets it into the cassette.
All that was hidden by the stove, now the stove is gone, it's not a good look inside the cupboard when we get that built by the carpenter mob beside the old workshop.

The macerator toilet is the correct height, plenty of bowl room complete with the extended bit I made to place the macerator pump under the floor, so the download goes straight to the chopper blades, just have to be careful not to lean back on the switch and start it running while I'm still seated, don't want a similar result as the ATR button on bidet

T1 Terry

[T1 Terry]

Dot, why can't you flush with the lid up. Sometimes its the most exciting part of the exercise.

Had one nasty back splash just pressing the pedal with out the vac pump running, fortunately it was only urine and I didn't get a back log .. or a log back more precisely. Seems it built up pressure in the pipework and the rush of air back up sent the bowl contents up and out ... fortunately it was and not or I might have ended up with a taste simply brushing the teeth might not remove
Learnt from that one that you turn the pump on before using the pedal

T1 Terry

[supersparky]

It wouldn't make much difference Terry, it's already been through your system once. It's a lot worse if it was a strangers.

[supersparky]

Good morning All.
Bernie, do you have to use a step ladder to get to the microwave? ......
.......
George

George, you should know that Bernie doesn't cook, so it would only be a problem for Carol. But that fridge is less than 1500mm high anyway. It would need to be a real high cupboard to make it unreachable.

[T1 Terry]

It wouldn't make much difference Terry, it's already been through your system once. It's a lot worse if it was a strangers.

At least it was on the inside and in the form of a beer when it went in the first time .... it would have been like drinking XXXX I suppose, not something I'd do willingly

T1 Terry

[T1 Terry]

Just removed the pipes from the toilet, not all the contents has gone through to the keeper .... I'm not sure my diaphragm muscles will ever recover .... but at least I didn't add to the mess on the floor Can't wait to get that thing out and a proper toilet in it's place

T1 Terry

[Dot]

Terry, George suspects the loo pipes have not been installed correctly. based on the installation book which says that the height difference between the loo and the cassette should not exceed 800mm a rise of 1m and a number of bends leads me to believe that the installation procedure was incorrect our vacuum loo works perfectly. Our friend in the airline business says to use crushed ice every now and again, it scrapes any bits off the insides of the pipes. The seal O rings also need attention by using O ring grease. Seems the prev owner was not forthcoming.