Our "New to Us" Winnie

[T1 Terry]

After a week or more of disassembly of the Winnie steps fiasco, then fabrication of a better mounting method, some photos

Not easy to do it turns out, and I had to do 8 of them

Winnie square hole drilled.jpg

for those wondering why I needed to drill a square hole

Winnie step bolts.jpg

This was because there would be no access to the bolt heads to use countersunk Allen key bolts and they couldn't be tack welded in place because the bolts needed to be removeable to get the frame out.

Measured the size the bracket needed to be so the bottom of the steps didn't drop below the body skirt when folded away

Winnie 3 step problem 2.jpg

Can you see the problem

Winnie 3 step problem.jpg

The steps need to come out as they drop open, the top step gets caught behind the body skirt so can't deploy them ......

The fix is either cut up the body skirt, or go back to a two step system ......

If I drop the steps down lower, there is a risk of them bottoming out over steep driveways etc .... I'll sleep on the problem and see if I wake up with a fix or just a migraine

The Jenga from patio has been reconstructed as an extended temporary arrangement

T1 Terry

[Dot]

The top pic ie the square hole is it really a peep hole? I see your little nose and sparkling teeth in that pic.
Are you up for a visit tomorrow sometime?

[T1 Terry]

The top pic ie the square hole is it really a peep hole? I see your little nose and sparkling teeth in that pic.
Are you up for a visit tomorrow sometime?

You have a wild imagination Dottie I'm guessing it is the edge of the truck body you can see through the peep hole, the frame was in the vice and it is mounted to the truck tray

Margaret says after lunch would be a good time for a visit, she has a morning workout at the gym after taking the dog for his morning walk. This retired thing keeps one very busy

T1 Terry