Not all email going through?

Dot · Post by **Dot** » Thu Feb 27, 2014 9:59 pm

Have been having a wee bit of a dilemma a few times. Sent an email and only about half arrived to the other end. This happened twice to the same person. Any thoughts ?

supersparky · Post by **supersparky** » Thu Feb 27, 2014 10:27 pm

Dot, Was it just a body of text or some photos and words. Sometimes when I get a document and attachments or photos the photos take forever to arrive/ appear.
This usually only happens when I am getting low on my monthly data allocation reserve.

Dot · Post by **Dot** » Thu Feb 27, 2014 11:13 pm

Tried to send a fresh new one to the same person and only 2 lines went through out of about 10 lines. Was just plain old writing and am ok for time as well.

generdawg · Post by **generdawg** » Fri Feb 28, 2014 10:36 am

Dot wrote:... only 2 lines went through out of about 10 lines.....

Jus a minute and I'll check to see if you are on ASIO's censorship radar Dottie. Nope, must just be a poor soldier joint or bent wire somewhere at your place.

Chuck · Post by **Chuck** » Fri Feb 28, 2014 4:21 pm

generdawg wrote:
Dot wrote:... only 2 lines went through out of about 10 lines.....
Jus a minute and I'll check to see if you are on ASIO's censorship radar Dottie. Nope, must just be a poor soldier joint or bent wire somewhere at your place.

Yair... it'll be an old bent over Digger for sure!

Dot · Post by **Dot** » Fri Feb 28, 2014 9:08 pm

I'm gunna bend your wire Chuck so be prepared

Post by **BruceS** » Fri Feb 28, 2014 10:13 pm

http://social.technet.microsoft.com/For ... progeneral

You're not alone Dot.
Time for Thunderbird?

Dot · Post by **Dot** » Fri Feb 28, 2014 10:21 pm

So it wasn't my vivid imagination then? (Take note Brad & Chuck)

Chuck · Post by **Chuck** » Sat Mar 01, 2014 9:01 am

Umm....

Firstly. My limited scientific knowledge tells me that to bend something you first must have some rigidity...

The term 'dangling participle' comes to mind.

Secondly. Bugger, forgot it!!

Dot · Post by **Dot** » Sat Mar 01, 2014 1:38 pm

QWell after "playing around" with knobs and buttons with this machine last night things have gotten more confused so that is it for me, Jenny & Mike aka Aussiegirl will be here some time so guess who has a job?

https://www.ozervnews.com

Not all email going through?

Not all email going through?

Re: Not all email going through?

Re: Not all email going through?

Re: Not all email going through?

Re: Not all email going through?

Re: Not all email going through?

Re: Not all email going through?

Re: Not all email going through?

Re: Not all email going through?

Re: Not all email going through?