Bernie and Carols Isuzu fit out.

[bob r]

Havta strain that ringlock up a bit Bernie got a bit of slack in it.

Bob

[BruceS]

Look again Bob!!
I reckon it's hingelock? Much better for straightening up!!

[BernieQ2]

Not mine was like that when we bought the place its just a 1/2 acre block behind us , no animals to keep in or out .
That's my story and I'm sticking with it .
Bernie .

[jon_d]

Hi Bernie,

There is a recommendation in the manual to flush out the oil cleaner. Sounds like they gunk up.

jd

[BernieQ2]

Already done Jon .
Thanks .
Bernie .

[jon_d]

Did much gunk come out?

[BernieQ2]

No Jon just oil . I flushed it with degreaser then with petrol .
Bernie.

[BernieQ2]

I have taken the oil cooler from the cover to show what it looks like Jon .
There is damage to the out side cover from electrolysis not enough to be a problem .
Bit foggy here this morning .
Bernie .

DSCF2804 (Custom).JPG

DSCF2805 (Custom).JPG

DSCF2806 (Custom).JPG

[BernieQ2]

After scratching around the cover with oil cooler removed I found what I didn't want corrosion not visible from the outside
but with a small screw driver the worst was revealed . Obviously been run at some time in its life without coolant .
So now need a new cover .
Bernie .

DSCF2807 (Custom).JPG

DSCF2808 (Custom).JPG

[BruceS]

Oh no!
Is it only in one place bernie?
I had holes in an aluminium heat exchanger on a boat some time ago & my friend bogged it up, ground it down flat and it looked like a new one.
I think it was made by Loctite and was some sort of epoxy alum compound. He said he'd even used it to rebuild ring grooves in pistons.
http://www.ebay.com.au/itm/LOCTITE-3805 ... OSw-K9ZJ6b~