What did you do to your rig today?

BernieQ2 · Post by **BernieQ2** » Fri Jul 15, 2016 5:03 am

Terry mate that knot was proberly put in the wiring to stop too much lectricity getting thru , I thought you would've picked up on that bit . hehe .
Bernie .

Busman · Post by **Busman** » Fri Jul 15, 2016 7:52 am

Fitting up the 8 channel mobile DVR which records all 8 cameras and allows you to access them remotely. Also does vehicle tracking.
And finishing some fibreglass repairs to the rear cap after jacknifing the trailer, bloody ejit !

Post by **T1 Terry** » Fri Jul 15, 2016 8:28 am

BernieQ wrote:Terry mate that knot was proberly put in the wiring to stop too much lectricity getting thru , I thought you would've picked up on that bit . hehe .
Bernie .

A current limiter, I should have realised that...... should we have put a knot in the replacement cable?

supersparky · Post by **supersparky** » Sat Jul 16, 2016 6:59 pm

Automotive wiring, gee isn't it fun when some less than suitable wiring method has been employed. Green, blue, black, who cares what the colours are when it is working fine. It's only when you are having a problem that it is an issue. One of my bosses told me a few years ago that a good electrician doesn't need a wiring diagram. That is of course until they get overheated and the smoke gets out and the insulation fails to exist.
Just put a little loop in the wire, not a proper knot. It will only put a little bit more into the total impedance of the circuit

Sorry.

Dot · Post by **Dot** » Sat Jul 16, 2016 7:21 pm

Put all the washed stuff back into the bus and even made the bed. G changed the water filters and flushed out the water tanks.

Dot · Post by **Dot** » Sun Jul 17, 2016 2:08 pm

annode.jpg

No wonder the water temp etc wasn't as good as it was before

Mrcoolabah1au · Post by **Mrcoolabah1au** » Sun Jul 17, 2016 2:32 pm

Pulled some more wire out

SteveW · Post by **SteveW** » Sun Jul 17, 2016 3:24 pm

Dot wrote:
annode.jpg
No wonder the water temp etc wasn't as good as it was before

Still a bit of life left in that one, Dot.

I bet George had to dig deep in his odd sockets bin to find the one that fits.

Mrcoolabah1au · Post by **Mrcoolabah1au** » Sun Jul 17, 2016 3:35 pm

But a new fuse block in to replace all that i took out

supersparky · Post by **supersparky** » Sun Jul 17, 2016 4:52 pm

Dot, That is just the sacrificial anode from the HWS, isn't it? It shouldn't have changed the HWS ability to make hot water.

And on our MH today I done nothing.

Wayne have you finished pulling out wire from the bird nest yet?

https://www.ozervnews.com

What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?

Re: What did you do to your rig today?