Slide out access to batteries - For T1

Cuppa · Post by **Cuppa** » Tue Jan 21, 2020 10:06 pm

Does this show the negative cable connected to positive terminals? Enlarge to see my annotation.

Waynes batteries.jpg

Mrcoolabah1au · Post by **Mrcoolabah1au** » Tue Jan 21, 2020 10:45 pm

Yes thanks I think so look at so old photo when we first set up but wait till terry see it tomorrow maybe bruce. Drawing is write

Mrcoolabah1au · Post by **Mrcoolabah1au** » Wed Jan 22, 2020 9:48 am

Change one thing this morning the cable connecting the two half can get 9 volt now so what now have written on the backing plate were the red and black

Post by **BruceS** » Wed Jan 22, 2020 10:54 am

I thought you were waiting for Terry Wayne?
I'll be seeing him shortly & will mention it to him.
Maybe a new photo? Where are you testing with your multi meter or was it Junsi showing 9V?

Cuppa · Post by **Cuppa** » Wed Jan 22, 2020 1:13 pm

BruceS wrote: ↑Wed Jan 22, 2020 10:54 am
Maybe a new photo?

Essential I think

Mrcoolabah1au · Post by **Mrcoolabah1au** » Wed Jan 22, 2020 1:59 pm

Thanks Bruce follow your drawing

now have 13.5 volts

Post by **T1 Terry** » Wed Jan 22, 2020 2:04 pm

OK Wayne, I think we need to start at the beginning, so I need you to take all the links off again and take a photo looking down from the centre. That way I can draw where each link should go. I have no idea which is positive and which is negative on each cell when the connectors are still on there.
Best not to keep trying different combinations, do you remember what happened here at the workshop when you put a link in the wrong place

EDIT:
I see you have posted since I started writing this post (had a customer call in the middle of it) If you now have the 13.2v all good I guess.

Vik351 · Post by **Vik351** » Fri Jan 24, 2020 11:51 am

My slide

BUJK0763 (1).JPG

vik...

Mrcoolabah1au · Post by **Mrcoolabah1au** » Sun Jan 26, 2020 1:30 pm

Wow vik yes like that idea how did you build it mate can I get some ideas

Vik351 · Post by **Vik351** » Sun Jan 26, 2020 11:12 pm

Mrcoolabah1au wrote: ↑Sun Jan 26, 2020 1:30 pm Wow vik yes like that idea how did you build it mate can I get some ideas

T 1 jobbie

All my idea of course

vik...

https://www.ozervnews.com

Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1

Re: Slide out access to batteries - For T1