
That turned out to be:
can you put the microwave from the bus in the house to replace the old one
In actual fact, the job description was:
Remove all the brackets holding the fridge in place and slide the fridge out
Remove the 8 screws from the plastic angle mounts that hold the shelf up that the microwave is mounted on
Drill out the rivets anchoring the microwave to the "L" brackets screwed into the shelf
Carry the microwave out of the bus and to the patio table
Remove the old microwave
At this point the controller of operations realised the difference in physical size

Utilising skills gathered from my past working life, I picked up a tape measure and measured the microwave and the space available ..... I guess that's just a "man" thing

Yes, it will fit, but no room for fingers either side ... or even another layer of paint
After due diligence was performed with the spray bottle and cloth, it is now installed and test run making myself a cup of coffee
No doubt the previously mentioned controller will examine the bus interior and I'll be in for more pain and demands I put the fridge back in place, after I lay the required coasts of Estapol on the untreated floor section where the fridge was, then refit the shelf, then resecure the fridge ... until the replacement inverter microwave/air fryer is purchased, then the next part of the plan will be revealed .....
T1 Terry